Connecting the wiring cable, Connecting the wiring cable -5 – KEYENCE LK-CC100/DN100 User Manual
Page 19
Advertising
2-5
2
2 Connecting to CC-Link
Connecting the wiring cable
Connect the prepared wiring cable to the field network connector (terminal block).
The field network connector is designed for multidrop connection of slave devices.
1
Insert each signal line into the holes in the connector.
Before inserting the communication cable, loosen the connector clamp screws.
2
Secure each signal line by tightening the clamp screws on the side of the
connector.
Wiring varies depending on the network controller.
Insert the applicable signal lines into the connector.
Reference
Insert into corresponding connector
NOTE
Secure by tightening clamp screw
Advertising