Changing the devicenet communication unit settings, Field network connection specifications, Changing the devicenet communication – KEYENCE LK-CC100/DN100 User Manual
Page 43: Unit settings -7, Field network connection, Specifications -7
3-7
3
3 Connecting to DeviceNet
Changing the DeviceNet Communication
Unit Settings
This section explains the principle and operation of the DeviceNet controller (LK-DN100).
This manual describes only those functions and settings of the DeviceNet master device necessary for
communicating with the LK-DN100. Refer to the manual supplied with the master device for details on
functions and settings between the DeviceNet master device and a PLC.
Field network connection specifications
Slave attributes
Notes on device profiles (attribute files for DeviceNet)
The table below shows the contents of the device profile.
General data
Vendor name
KEYENCE Corporation
Vendor ID
367
Device profile name
Generic
Profile No.
0
Product catalog number
3000
Product revision
1.1
Physical conformance data
Maximum network power
consumption
-
Connector type
Open-ended screw connector
Physical layer insulation support
Yes
Support LED
Module, Network
MAC ID setting
Node Address switch
Default MAC ID
63
Transmission baud rate setting
Data Rate switch
Support transmission rate
125 kbps, 250 kbps, 500 kbps
Communication data
Predefined Master/Slave
Group 2-only server
Connection Set support
UCMM and message group
support
N/A
Message splitting support for
sending
Compatible
NOTE