Installing the scale, Setting up the scale, Procedure a – A&D Weighing HW-1200KGV3 User Manual
Page 12
Page 10
HV-G/HW-G Series
5. Installing the Scale
5. Installing the Scale
5.1. Setting up the Scale
The setup procedure depends on the scale model. Refer to the table below.
Models
Refer to
HV-15KGL/HV-15KGV/HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-10KGL
HW-10KGV/HW-60KGL/HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGV
Procedure A
HW-300KGL4/HW-300KGV4/ HW-600KGL4/HW-600KGV4
Procedure B
HW-600KGL3/HW-600KGV3/ HW-1200KGL3/HW-1200KGV3
Procedure C
5.1.1. Procedure A
HV-15KGL/HV-15KGV/HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-10KGL
HW-10KGV/HW-60KGL/HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGV
This procedure includes all of the steps for installing
the scales described above. Therefore, there may
be some unnecessary steps for some models.
Step 1 Take the base unit and pole out, taking care
not to pull on the load cell cable.
Step 2 Place the pan on the base unit.
Step 3 Attach the pole to the bracket of the base
unit, while using care not to damage the load
cell cable.
Insert the remainder of the load cell cable
into the pole.
Affix the pole to the bracket using two Allen
screws.
Step 4 Select a place for installing the scale. Refer
to "4.1. Installing the Scale” .
Step 5 Adjust the level of the base unit using the
bubble spirit level and the leveling feet.
Step 6 Press the caps at the pole top from both
sides and adjust the angle of the display unit.
Step 7 Check the weighing accuracy. If the scale
needs calibration, refer to "14. Calibration".