A&D Weighing HW-1200KGV3 - Manual (Page 56)

Page 54 HV-G/HW-G Series 15. The Function Table
Item Display Description
Ａ
f8 4
When the display is a stable value and not nearly-zero, the scale
accumulates the data automatically. The next accumulation can
be performed after the display becomes nearly-zero.
Use
Recording the number and mass of articles removed
from the pan. (Place the articles on the pan. Press the
TARE
key at each removal.)
A
A
A
A
A
A Accumulation
function
f8 5
At each end of the full/dribble batch function, the scale
accumulates the data automatically.
Use
Packaging articles like a powder, it is used for recording
the bag number and total mass.
A
A
A
A
Selects the printing condition. Option OP-06 for type V is
required. Ａ
f9 0 # No print. Ａ
f9 1 Press the
PRINT
key to output the data. Ａ
f9 2
Auto-print +
When the display becomes a positive stable value and not
nearly-zero, the scale outputs the data automatically. Next
output can be performed after the display becomes
nearly-zero or negative value.
Ａ
Ａ
Ａ
Ａ
Ａ
f9 3
Auto-print +/-
When the display becomes a stable value and not
nearly-zero, the scale outputs the data automatically. Next
output can be performed after the display becomes
nearly-zero. Ａ
Ａ
Ａ
Ａ
f9 4 At each end of full/dribble batch function, the data is output. Ａ
Print mode
f9 5 When the accumulation function is used, the data is output. Ａ
Selects the details of the full/dribble batch function (f6 9) Ａ
f10 0 #
When the
F
key is pressed after final value is reached, the
current process is finished.
A
A
f10 1
When the stability mark is displayed after final value is reached,
the current process is finished automatically. A
A
f10 2
When the
SET
key is pressed, the scale automatically tares and
starts the full/dribble batch process. When the
F
key is pressed
after final value is reached, the current process is finished
A
A
A
Full/Dribble
batch
sub-func-ti
on
f10 3
When the
SET
key is pressed, the scale automatically tares and
starts the full/dribble batch process. When the stability mark is
displayed after final value is reached, the current process is
finished.
A
A
A
Select the address for RS-422 / RS-485 for option OP-04 Ａ
f11 00 #
Address f11 01
to
f11 99
Use Addresses from 01 to 99 are available. Scales are
assigned unique addresses and are controlled by the
computer.
(RS-232C should be set to "00".)
Ａ
Ａ
Ａ
"#": factory settings. The "nearly-zero" is within ±5 digits from zero point in the unit of kg.