A&D Weighing HW-1200KGV3 - Manual (Page 24)

Page 22 HV-G/HW-G Series 6. Description of Each Part
Function table: used to select a parameter. A
Display and Symbols Description A
SET key, key
Normal weighing mode: used to turn the comparator on or
off. (Refer to f6 )
Counting mode: used to enter the mode to store the unit
mass.
Percentage mode: used to enter the mode to store the
100% mass.
Full/dribble batch function: used as a start key.
Preset tare and calibration mass selection: used to select
a figure.
A
A
A
A
A
A
A
A
MODE key, ENTER key
Used to change the current unit.
Setting mode: used to store a parameter and proceed to the
next step.
A
A
A
A
F key
Full/dribble batch function: used to finish the process.
(Refer to f10 )
Hold key. (Refer to f12 )
Comparator function: used to select the polarity (+,-).
A
A
A
A
A
PRINT key
Used to print or output data. (Refer to f5, f9 )
A
A
A
Used to enter the function table.
A
A
A
A
A
A
Used to enter the mode to set a preset tare.
A
A
A
A
A
Used to feed the paper to the optional printer for type V.
A
A
A
A
A