A&D Weighing HW-1200KGV3 - Manual (Page 18)

Page 16 HV-G/HW-G Series
5. Grounding the scale
5.4. Grounding the scale
When using where there may be static electricity, ground the scale.
The grounding procedure depends on the scale model. Refer to the table below.
These procedures are only for grounding part of the scale.
Models Refer to
HV-15KGL/HV-15KGV/ HW-10KGL/HW-10KGV Procedure A
HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-60KGL/HW-60KGV
HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGV
Procedure B
HW-300KGL4/HW-300KGV4/ HW-600KGL4/HW-600KGV4 Procedure C
HW-600KGL3/HW-600KGV3/ HW-1200KGL3/HW-1200KGV3 Procedure D
Procedure A
(HV-15KGL/HV-15KGV/ HW-10KGL/HW-10KGV)
Secure the grounding cable using a M4 screw in the
screw hole between the two hexagon bolts on the
base unit bottom side. (Part of “ ”)
Procedure B
HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-60KGL/
HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGV
Secure the grounding cable using the screw that
secures the under cover. (Part of “ ”)
Procedure C
(HW-300KGL4/HW-300KGV4/ HW-600KGL4/HW-600KGV4)
Remove the pan. Secure the grounding cable using
the screw that secures the band of the load cell cable
bundle. (Part of “ ”)
Pull the grounding cable through to the lower section
through the channel. Be careful that the pan does not
touch the grounding cable.
Procedure D
(HW-600KGL3/HW-600KGV3/HW-1200KGL3/HW-1200KGV3)
Remove the pan. Secure the grounding cable using
the screw that secures the summing box. (Part of “ ”)
Remove the cover located on the base’s side. Pull the
grounding cable out through this hole. Be careful that
the pan does not touch the grounding cable.
Load cell
cable
Summing box
Cover
Base unit
bottom side
Levering feet
Under cover Base unit
bottom side
Pull the grounding
cable through to the
under side of the base.