A&D Weighing HW-1200KGV3 - Manual (Page 21)

HV-G/HW-G Series Page 19
6. Description of Each Part
6.1. Display and Symbols
Display and Symbols Description A
Stability mark
When the current weight value is stable, this mark is
displayed. It means a proper condition that this value is
readable.
A
A
A
A
Zero point mark
When the
ZERO key is pressed with nothing on the pan,
this mark is displayed. The zero point is the fundamental
starting point to weigh anything.
A
A
A
A
Net mark
When the
TARE key is pressed, this mark is displayed.
Used to indicate that the mass of the container placed
on the pan has been subtracted from the gross value.
A
A
A
Preset tare mark
While a tare with digital input is displayed, this mark
blinks. A
Accumulation mark
While the accumulation function is used, this mark is
displayed. A
A
Low battery mark for type L
When the battery is depleted (becoming low voltage),
this mark is displayed. Replace with six new batteries.
A
A
A
Ready mark for the full/dribble batch function. This mark
means as follows:
ON
The weight value is within the zero band.
OFF The full/dribble batch process is above the
zero band.
Blinking The start or end of the full/dribble batch
process is not within the zero band.
A
A
A
A
A
A
Weighing range indicator for the HV-G series
The current range is indicated. A
A
Comparator indicator
Using the comparator function:
Indicates the result after a weight value is
compared with the upper and lower limits.
Using the full/dribble batch function:
OK is the full flow gate indicator, HI is the dribble
flow gate indicator and LO is the zero band gate
indicator.
A
A
A
A
A
A
A
Zero point (Example)
When the
ZERO key is pressed with nothing on the pan,
the zero point mark and the stability mark are displayed.
A
A
A
A
A
STABLE
ZERO
Weighed mass value unit