Switching the word processor on/ojf, Power cord, Note – Brother WP-700D User Manual
Page 13: Power switch, Switching the word processor on/off
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Switching the Word Processor On/Ojf
Power Cord
NOTE:
Please be sure both yellow plastic packing pieces have been removed from
the word processor before the power is turned on.
The power cord is stored in a compartment on the
back of the word processor. The cover of that
compartment is also used as a paper support.
NOTE:
It is a good idea to disconnect the AC plug
when the word processor is not used for a
long period.
Always disconnect the power
cord during thunderstorms.
Power Switch
Flip the power switch on. The switch is located on
the left side toward the rear of the word proces
sor.
NOTE:
If the word processor does not respond,
check the power cord and then make sure
that the acoustic cover is securely latched.
Adjust the display brightness with the brightness
controller next to the screen.
NOTE:
If you switch the word processor off, wait at
least 10 seconds before switching it on again.
Failure to wait 10 seconds may disrupt the
start-up sequence, resulting in faulty
operation and possible equipment dam
age.