Brother WP-700D - Manual (Page 81)

1. Press II— to display the menu.
2. Use ® and Q to select DISK COPY, and press
message appears:
j. The following
Insert source disk and press RETURN.
• Accelerator: Instead of (2), type “O”.
3. Insert the source (original) diskette and press [RETURN]. The word processor
will start reading files from the source diskette. Since the memory space is
limited, the word processor may not be able to read all files in one step. After
a while, this message will appear:
Insert destination disk and press RETURN.
4. Insert the destination diskette and press I retur M . The word processor will
transfer the files that have been read from the source diskette onto the desti­
nation diskette. If all the files of the source diskette have not been transferred
yet, the word processor will ask you to re-insert the source diskette, repeat
steps (2) and (3) until all files have been transferred to the destination dis­
kette. You may need to swap these diskettes a number of times before all of
the files are copied to the destination diskette.
NOTE:
The word processor “knows” which diskette is the source diskette and which
one is the destination diskette. If you mistakenly insert a wrong diskette, one
of these messages will appear:
Incorrect disk. Insert destinati ondisk and press RETURN.
Incorrect disk. Insert source disk and press REiURN.
NOTE:
You may press [CANCEL I at any time (except during diskette access) to cancel
the operation.
When copying is complete, the INDEX screen reappears.
73