Note – Brother WP-700D User Manual
Page 156
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(f^
^ (SPACEBAR)
Cr.
BACKSPACE
Use KSPACEBAffil and IBAOCBRMigl to move the
carrier to the center of the platen.
Lift the acoustic cover and remove the ribbon
cassette, if installed. (See “Changing Ribbons”
on page 146.)
NOTE:
It is not possible to move the carrier while the
acoustic cover is open. Close the acoustic
cover to re-position the carrier.
Grasp the spools with your thumbs in the posi
tions shown and pull them off their mounts.
Bring the tape back to a position parallel with the
platen and then lift it up and out.
Pass the new tape through the left guide, behind
the ribbon guide, and out through the right guide.
The rough side of the tape should face the
platen.
Mount the feeder spool on the pin on the left and
the take-up spool on the pin on the right.
148