Toshiba LF600F - Manual (Page 119)

TOSHIBA 6,F,8A0i8|6|9,
Totalizer Operation
• Using control keys on the panel (option)
To start, stop or clear (reset) the totalizer, follow the procedure described below:
Key operation Display example Description
FLOW
2.000
m/s
RANGE1
5.000
m/s
fCNTl fSETl
The measured value is displayed (measurement
mode).
[CNT]
COUNT CTRL
TOTAL CNT
100
FOR
[STA] [CLR] [EXT]
Pressing the [CNT] key when you are in the
measurement mode causes the screen to switch to
the total counter operation screen.
In the sub display area of this screen, the total
counter value (both sides) is automatically
displayed.
In addition, the [STA], [CLR] and [EXT] keys are
displayed.
* When the total counter is operating, [STP] is
displayed. While the total counter is stopped, [STA] is displayed.
* If you enter a wrong password at password
setting, the [CLR] key is not displayed.
[STA]
COUNT CTRL
TOTAL CNT
100
FOR CNT
[STPl [CLR] [EXT]
Pressing the [STA] key causes the total counting to
start and "CNT" to be displayed on the screen. In
addition, the [STA] key changes to the [STP] key.
[CLR]
COUNT CTRL
TOTAL CNT
0
FOR CNT
[STP] [CLR] [EXT]
Pressing the [CLR] key causes the total counter
value to be cleared.
[EXT]
FLOW
2.000
m/s
RANGE1
5.000
m/s
Pressing the [EXT] key causes you to return to the
measurement mode.
Notes: 1. Since the flow direction code is B (bidirectional flow (Forward/Reverse directions) automatic
switching),
• When you select forward/reverse multi-range,
the forward direction totalized value (count value) is displayed for operation in the
forward direction range.
the reverse direction totalized value (count value) is displayed for operation in reverse
direction range.
2. When you reset the counter, the flow counts for both directions will be cleared to zero.
3. Non-volatile memory is used to store the totalizer counter value. Therefore, the value will be
retained in the memory even if the power is cut off.
-
118
-