Chapter 3: connection - syncing face id, Installations and communications, Ingress online activation – FingerTec Face ID 2 (FEM 600) Manual User Manual
Page 11: Installation and setup of ingress, Connecting terminals to ingress, Using usb to download/upload data, Connection - syncing face id
Advertising

12
3
•
CONNECTION - SYNCING FACE ID
Installations and Communications
At the rear of Face ID, there are connections available for
power and communications.
Back of Terminal
1
USB Port
Linking with USB flash disk for remote data transfer.
2
TCP/IP Port
Connecting with CAT cable for LAN connection, one end
to this port and another to the computer’s TCP/IP Port.
TCP/IP for Single Connection – Linking Face ID to
a single computer using TCP/IP requires Ethernet
10/100Base-T Crossover Cable.
The cable can be used to cascade hubs or to connect
Ethernet stations back-to-back without a hub. It works
with both 10Base-T and 100Base-TX.
Joint 1 Pin
Joint 2 Pin
TX+
1
•
•
3
RX+
TX-
2
•
•
RX-
RX+
3
•
•
1
TX+
RX-
•
•
2
TX-
1
8
TOP
FRONT
1
8
1
2
3
4
Advertising