Show ipsec – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 104
3-46
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Privileged Mode
show ipsec
Use the show ipsec command to display the IPSec Connections or the connection configuration
information.
Syntax:
# show ipsec [vpn_ipsec
connection-id]
Example:
adit 3500# show ipsec
vpn_ipsec 0
vpn_ipsec 1
vpn_ipsec 2
vpn_ipsec 3
Example:
adit 3500# show ipsec vpn_ipsec2
Device = test State = Enabled tatus = No VPN software license
Schedule Availability = Always
Remote Tunnel Endpoint Address = 192.168.1.200
Security Association Mode = Tunnel
Remote Subnet = None
Route NetBOIS Broadcasts = Enabled
Dead Period Detection = Disable
Remote Broadcast Address = 192.168.1.200
Key Exchange Method = Automatic
Auto_Reconnect = Enabled
Mode = Main Mode
Negotiation Attempts = 3
Rekey Life Time = 3600 sec
Rekey Margin = 540
Rekey Fuzz Percent = 100
Peer Authentication = Shared Secret
Shared Secret = mysecret
Encryption = 3des,
Hash = md5,sha1,
Group = grp2,grp5,
Lifetime = 28000 sec
Use PFS = Enabled
Group = Same group as phase 1
AH Transform = md5,sha1,
ESP Encryption Transform = esp-3des,
ESP Authentication Transform = esp-md5,esp-sha1,
IP Compression = Disabled
Default Route = Disabled
RIP = Enabled
RIP Listen Msg. = RIPv1/2
RIP Send Msg. = None
OSPF = Disabled
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
connection-id
Enter the name of a connection.