End-address, Exit, End -3 end-address -3 exit -3 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 405
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
18-3
Configuration - PPTPS Mode
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. This command can be entered in any configuration mode with the same result.
Syntax:
(config-pptps)# end
Example:
(config-pptps)# end
#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
end-address
Use the PPTP Server end-address command to set the PPTP remote host IP address range end.
Syntax:
(config-pptps)# end-address
end-ip-address
Example:
(config-pptps)# end-address 192.168.1.250
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-pptps)# exit
Example:
(config-pptps)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
end-ip-address
Enter the end IP address of the range.