Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 454)

24-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Trunk Mode
no registration line
Use the Voice Port Trunk no registration line command remove a registration line. To add a
registration line, see registration line enable command on page 24-13.
Syntax:
(config-vport-trk-{ n})# no registration line number
Example:
(config-vport-trk-1)# no registration line 1
Supported Platforms: Adit 3500, MSR
no registration line enable
Use the Voice Port Trunk no registration line enable command to disable a registration line. To
enable line registration, see registration line enable command on page 24-13.
Syntax:
(config-vport-trk-{ n})# no registration line number enable
Example:
(config-vport-trk-1)# no registration line 1 enable
Supported Platforms: Adit 3500, MSR
no registration line logging
Use the Voice Port Trunk no registration line logging command disable line logging on a PBX
line. To enable logging, see registration line logging command on page 24-14.
Syntax:
(config-vport-trk-{ n})# no registration line number logging
Example:
(config-vport-trk-1)# no registration line 1 logging
Supported Platforms: Adit 3500, MSR
Field Definition
number Enter line number to Remove. Range 1 -300. Note: This line must be
enabled for this command to be accepted.
Field Definition
number Enter line number to disable. Range 1 -300. Note: This line must be
enabled for this command to be accepted.
Field Definition
number Enter line number to disable. Range 1 -300.