No commands, No area, No area authentication – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 373: No area stub, No commands -7, Parameter. the no area command
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
16-7
Configuration - OSPF Mode
no commands
no area
Use the Router OSPF no area command to remove a specific area from the OSPF configuration.
To set an area, see the area commands command on page 16-2, or area stub command on
page 16-2, the first use of either command will set the area.
Syntax:
(config-ospf)# no area
area-id
Example:
(config-ospf)# no area 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no area authentication
Use the Router OSPF no area authentication command to remove an area’s authentication. See
the area commands command on page 16-2 for the counterpart of this command.
Syntax:
(config-ospf)# no area
area-id authentication
Example:
(config-ospf)# no area 1 authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no area stub
Use the Router OSPF no area stub command to remove the definition of an area as a Stub area. See
the area stub command on page 16-2 for the counterpart of this command.
Syntax:
(config-ospf)# no area
area-id stub
Example:
(config-ospf)# no area 1 stub
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
area-id
ID of area to be removed, in the form:
area number - Range 0-4294967295
area IP address - IP address of the area.
Field
Definition
area-id
Area ID for which authentication is to be removed, in the form:
area number - Range 0-4294967295
area IP address - IP address of the area.
Field
Definition
area-id
Identifier of the stub area, in the form:
ID number - Range 0-4294967295
IP address - IP address of the area.