Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 132)

4-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
Example:
(config)# access-list rule new apply eth-lan direction in
operation accept time-range always src-host any dst-host any
service 16777220 frag none log none
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
authentication login
Use the authentication login command to use RADIUS for login authentication. To remove an
authentication login, see no authentication login command on page 4-37.
Syntax:
(config)# authentication login use-radius
Example:
(config)# authentication login use-radius
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
clock source
Use the clock source command to define the primary and secondary clock source.
Syntax:
(config)# clock {1|2} source {none|t1 port}
Example:
(config)# clock 1 source t1 2
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
Not supported by the MSR card
frag enable - Enable fragmentation.
none - Do not allow fragmentation.
log Enable or disables logging of packets matched by this rule.
Field Definition
1|2 Sets the interface to the following clock source.
1 = Clock 1, primary clock source
2 = Clock 2, secondary clock source
none Sets the clock source to internal.
t1 port Sets the clock source to a DS1. Range is 1-4.
Field Definition (Continued)