Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 351)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-9
Configuration - L2TPC Mode
ip ospf priority
Use the L2TPC ip ospf priority command to set the router priority, which determines the designated
router for this network. To restore the default setting of priority 1, see no ip ospf priority command on
page 15-16.
Syntax:
(config-l2tpc-{n})# ip ospf priority priority
Example:
(config-l2tpc-1)# ip ospf priority 2
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip ospf retransmit-interval
Use the L2TPC ip ospf retransmit-interval command to define the interval of time between link state
advertisement retransmissions for adjacencies belonging to the interface. To restore the default value of
5 seconds, see no ip ospf retransmit-interval command on page 15-16.
Syntax:
(config-l2tpc-{n})# ip ospf retransmit-interval seconds
Example:
(config-l2tpc-1)# ip ospf retransmit-interval 10
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip ospf transmit-delay
Use the L2TPC ip ospf transmit-delay command to define the estimated time to transmit a link state
update packet on the interface. To restore the default value of 1 second, see no ip ospf transmit-delay
command on page 15-17.
Syntax:
(config-l2tpc-{n})# ip ospf transmit-delay seconds
Example:
(config-l2tpc-1)# ip ospf transmit-delay 10
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
priority Enter an ID for this key. Range is 0-255.
Field Definition
seconds Range is 1-65535 seconds, with a default of 5.
Field Definition
seconds Range is 1-65535 seconds, with a default of 1.