Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 271)

C
HAPTER
12
Configuration - Multilink Interface Mode
The Multilink Interface Configuration commands allow the user to configure the MLPPP parameters.
Enter this sub-group with the (config)# interface multilink number command from the Configuration
mode. The Multilink Interface commands are represented by the (config-int-mlink-{n})# prompt.
Note: Before configuring MLPPP parameters, you must create a multilink group from the
corresponding Serial interface. Use the multilink-group command to create the group.
Multilink Interface Commands
• description • ip rip
• do • ip route
• end • ip route-mode
• exit • ip secondary-dns
• firewall • metric
• history • no commands
• ip address • ppp authentication
• ip default-route • ppp encryption
• ip mtu • ppp exec-timeout
• ip ospf authentication • ppp link-fragmentation
• ip ospf authentication-key • ppp on-demand
• ip ospf cost • ppp password
• ip ospf dead-interval • ppp qos-interleaving
• ip ospf disable • ppp restart-timer
• ip ospf hello-interval • ppp time-btwn-reconnect
• ip ospf message-digest-key • ppp username
• ip ospf priority • schedule-availability
• ip ospf retransmit-interval • shutdown
• ip ospf transmit-delay • sip-alg
• ip primary-dns