Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 422)

20-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - VLAN Mode
port-protocol-filter
Use the VLAN port-protocol-filter command to enable VLAN filtering for the port.
Note: The vlan-feature command, on page 20-7, must be executed before this command.
Syntax:
(config-vlan)# port-protocol-filter {disable|enable} ethernet
port
Example:
(config-vlan)# port-protocol-filter enable ethernet 1.1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
pvid
Use the VLAN pvid command to set the port native VLAN ID, or PVID.
Syntax:
(config-vlan)# pvid ethernet port
Example:
(config-vlan)# pvid ethernet 1.1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
disable Disable VLAN filtering on defined Ethernet port.
enable Enable VLAN filtering on defined Ethernet port.
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 and MSR: 1.1 and 2.1
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 and MSR: 1.1 and 2.1