Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 245)

C
HAPTER
11
Configuration - Ethernet Interface Mode
The Ethernet Interface Configuration commands allow the user to configure the Ethernet interface
parameters.
Enter this sub-group with the (config)# interface ethernet command from the Configuration mode.
The Ethernet Interface commands are represented by the (config-int-eth-{n})# prompt.
Ethernet Interface Commands
• description • ip ospf priority
• do • ip ospf retransmit-interval
• end • ip ospf transmit-delay
• exit • ip primary-dns
• firewall • ip proxy-arp
• full-duplex • ip rip
• half-duplex • ip route
• history • ip route-mode
• ip address • ip secondary-dns
• ip default-gateway • metric
• ip default-route • no commands
• ip dhcp • release
• ip mtu • remote-admin
• ip ospf authentication • renew
• ip ospf authentication-key • schedule-availability
• ip ospf cost • shutdown
• ip ospf dead-interval • sip-alg
• ip ospf disable • speed
• ip ospf hello-interval • tos
• ip ospf message-digest-key