Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 208)

6-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - T1 Controller Mode
no shutdown
Use the Controller T1 no shutdown command to set the T1 up (In-Service). To set the T1 down
(Out-of-Service), see shutdown command on page 6-11.
Syntax:
(config-cont-t1-{ n})# no shutdown
Example:
(config-cont-t1-1)# no shutdown
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
no tdm-group
Use the Controller T1 no tdm-group command to ungroup TDM timeslots. To group TDM
timeslots, see tdm-group command on page 6-11.
Syntax:
(config-cont-t1-{ n})# no tdm-group timeslots range
Example:
(config-cont-t1-1)# no tdm-group timeslots 1-4 dir
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
pri-group
Use the Controller T1 pri-group command to group PRI timeslots. To delete a PRI group, see
no pri-group command on page 6-9.
Syntax:
(config-cont-t1-{ n})# pri-group timeslots range dir
{in|in-out|out}
Example:
(config-cont-t1-1)# pri-group timeslots 1-4
Supported Platforms: Adit 3104, Adit 3500
Field Definition
range TDM timeslot range, in the format n-n (1-4). Range is 1 - 24.
Field Definition
range PRI timeslot range, in the format n-n (1-4). Range is 1 - 23.
in Defines the direction as incoming only.
in-out Defines the direction as both incoming and outgoing.
out Defines the direction as outgoing only.