Registration line logging, Signal, Signal -14 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 458
24-14
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Trunk Mode
registration line logging
Use the Voice Port Trunk registration line authentication command to enable logging on this line.
To disable logging, see no registration line logging command on page 24-10.
Syntax:
(config-vport-trk-{
n})# registration line value line-numbers
value logging
Example:
(config-vport-trk-1)# registration line 4 line-numbers 3 logging
Supported Platforms:
Adit 3500, MSR
signal
Use the Voice Port Trunk signal command to configure the trunk signal type for a CAS trunk.
Syntax:
(config-vport-trk-{
n})# signal {delay-dial|immediate|
wink-start}
Example:
(config-vport-trk-1)# signal immediate
Supported Platforms:
Adit 3500, MSR
Field
Definition
line value
Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that is going to be registered.
Starting from the first-phone-number, increased by 1 each.
Field
Definition
delay-dial
Set the trunk to CAS Delay Dial signaling.
immediate
Set the trunk to CAS Immediate Start signaling.
wink-start
Set the trunk to CAS Wink Start signaling.