Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 234)

9-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer Trunk Mode
no commands
no codec preference
Use the Dial Peer no codec preference command to remove a codec preference. To set the
preferences, see codec preference command on page 9-2.
Syntax:
(config-dpeer-trk)# no codec preference {1|2|3}
Example:
(config-dpeer-trk)# no codec preference 1
Supported Platforms: Adit 3500, MSR
no destination-pattern
Use the Dial Peer no destination-pattern command to remove a destination pattern. To set the
destination pattern, see destination-pattern command on page 9-2.
Syntax:
(config-dpeer-trk)# no destination-pattern
Example:
(config-dpeer-trk)# no destination-pattern
Supported Platforms: Adit 3500, MSR
no sip-authentication
Use the Dial Peer no sip-authentication command to disable SIP authentication. To configure SIP
authentication, see sip-authentication command on page 9-7.
Syntax:
(config-dpeer-trk)# no sip-authentication
Example:
(config-dpeer-trk)# no sip-authentication
Supported Platforms: Adit 3500, MSR
Field Definition
1|2|3 Set the preference level. Range 1 - 3.