Full-duplex, Half-duplex, Full-duplex -5 half-duplex -5 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 249
Advertising
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
11-5
Configuration - Ethernet Interface Mode
full-duplex
Use the Ethernet Interface full-duplex command to specify the Ethernet PHY (physical specifications)
mode to full duplex.
Syntax:
(config-int-eth-{
n})# full-duplex
Example:
(config-int-eth-1)# full-duplex
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
half-duplex
Use the Ethernet Interface half-duplex command to specify the Ethernet PHY (physical specifications)
mode to half duplex.
Syntax:
(config-int-eth-{
n})# half-duplex
Example:
(config-int-eth-1)# half-duplex
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Advertising