Date summer-time – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 135
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
4-9
Global Configuration Mode
Global Configuration Commands
date summer-time
Use the date summer-time command to update the clock for daylight savings time. To stop the
update for daylight saving, see no date summer-time command on page 4-38.
Note: Default settings are start: 3/28 time 00:00, end: 10/28 time 01:00.
Syntax:
(config)# date summer-time
smonth sday shh:mm emonth eday ehh:mm
offset
Example:
(config)# date summer-time 03 28 00:00 10 28 01:00 60
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Note: By default, Time of Day management for the MSR is provided by the Adit 600 controller.
Use this command with the MSR only if you are using NTP or another time service and need to
manually adjust the time due to a loss of contact with the server.
Field
Definition
smonth and emonth
The month in which daylight savings time starts (smonth) or ends
(emonth). Range is 1-12.
sday and eday
The day on which daylight savings time starts (sday) or ends (eday).
Range is 1-31.
shh:mm and ehh:mm Start time (shh:mm) and end time (ehh:mm).
hh = hour, range 00:59
mm = minutes, range 00:59
offset
This is an optional parameter, to set the offset of the daylight savings
time. Range is 1-120, with a default of 60.