One-step buttonholing – SINGER 2001 TouchTronic User Manual
Page 105
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
one-step buttonholing
Your machine offers you two different widths
of bar tack buttonholes made by a one-step
method of stitching. Buttonholes can be made
up to 1-1/2 inches (3.8cm) long using the
one-step foot. The maximum size fiat button
that the buttonhole will accept is 1 -3/8 inches
(3.5cm). To determine which buttonhole —
standard or shirt-type — best suits your gar
ment and fabric, aiways make a test but
tonhole on a sample of fabric, with interfacing,
if being used.
Raise presser foot lifter.
Remove presser foot.
Attach general purpose needle plate. Attach
one-step buttonhole foot.
To attach one-step buttonhole foot, place but
tonhole foot behind the needle, then guide it
forward. Center the foot under the shank and
lower the presser foot lifter so that the shank
fits over the presser foot pin.
Press presser foot screw down firmly until foot
snaps into place.
Switch machine on SLOW.
91