Changing needle plates – SINGER 2001 TouchTronic User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING NEEDLE PLATES
Remove bobbin if it contains thread in order to
prevent thread being caught when plate is
replaced.
Raise needle and take-up lever to highest
position by turning the hand wheel toward you.
Raise presser foot.
• Open slide plate. Press down on front edge
of needle plate and lift up and out.
• When changing to straight stitch needle
plate, move feed to right-hand position.
Move Feed to Right-Hand Position when Using
Straight Stitch Needie Piate
• When changing from straight stitch needle
plate to any other needle plate, move feed to
left-hand position.
•
• Position new plate over pins and release.
Plate is drawn into position by magnets. See
special instructions on page 10 for attach
ing chainstitch plate.
• Close slide plate.
Machine has been designed with a movable
feed. This allows close contact between feed
and presser foot when straight stitching and
is beneficial in helping to hold fabric in place
while stitching.
Move Feed to Left-Hand Position when Using
Generai Purpose Needle Plate
Caution:
The straight stitch foot and zipper
foot must oniy be used with the straight stitch
needle plate. Needle breakage can occur if the
straight stitch foot or zipper foot is used with
any other needle plate.