SINGER 2001 TouchTronic - Manual (Page 16)

Post
Bobbin
Latch
Finger
of Insert
Attaching Chainstitch Fittings
Chainstitch Needle Plate and Insert
• Raise needle and take-up lever to highest
position and raise presser foot.
• Open slide plate.
• Move bobbin latch to left and remove bobbin
and needle plate from machine.
• Place bobbin case insert in bobbin case as
shown, with finger of insert positioned under
the feed.
• Position chainstitch needle plate over mag­
netic pins, making certain that the post of
the bobbin case insert finger enters the hole
in the plate.
• Close slide plate.
ATTACHING THE SEAM GUIDE
Place screw in hole to the right of the slide
plate; line up straight edge of guide with the
needle plate guideline for desired seam width
and tighten screw.
ADJUSTING THE ZIPPER FOOT
How the zipper is inserted will depend on the
type of garment and location of the zipper.
Check your zipper package for zipper insertion
information. For information on attaching zip­
per foot to presser foot shank, refer to page 8.
To adjust foot, loosen the thumb screw at the
back of foot and slide foot to either the left or
right of the needle. Check the position of the
foot by turning the hand wheel to lower the
needle into the side notch of the foot, making
sure it clears the foot. Lock the foot into posi­
tion by tightening the thumb screw.
10