SINGER 2001 TouchTronic User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

We recommend the use of a moderate
speed when winding a bobbin.

1. Move bobbin latch A to extreme right.

2. Draw needle thread away from you bet­

ween toes of presser foot, under left
side of presser foot, then up from the
front into and around thread retainer B.

Release thread end. Start machine, run
at moderate speed.

3. Pull thread end away after it has sepa­

rated from bobbin.

• Watch the bobbin as it fills. Do not

allow thread to wind beyond the out­
side FULL ring C.

4. Close slide plate to release bobbin

latch to sewing position.

To start sewing, pull thread back under

presser foot and cut. Place threads diagonally
under foot to left side, position needle in

fabric where desired, lower presser foot, and
start machine. For additional information on
starting to sew refer to Chapter 4, Straight
Stitching page 41.

24

Advertising
This manual is related to the following products: