Chapter 2. getting ready to sew, Choosing and changing accessories, Changing presser feet – SINGER 2001 TouchTronic User Manual
Page 13: Snap-on presser feet, To remove foot, Chapter, Getting ready to sew
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 2. Getting Ready to Sew
choosing and changing accessories
CHANGING PRESSER FEET
Snap-on Presser Feet
Most of the presser feet furnished with your
machine snap on and off a common shank.
• Raise needle and take-up lever to highest
position by turning the hand wheel toward
you.
• Raise presser foot.
To Remove Foot
. rress lUB ui Mil
far as it will go.
as
2. Center the new presser foot under the
shank.
Lower the presser foot after so that the
shank fits over the presser foot pin.
1b. Then snap down to remove.
3. Press presser foot screw down firmly
until foot snaps into place.
To remove and replace the shank of
snap-on presser feet, follow instructions
on next page for one-piece presser feet.