SINGER 2001 TouchTronic User Manual

Page 111

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Attaching a Button (Cont.)

4. Lower button foot.

• Turning hand wheel toward you, lower nee­

dle close to button surface.

5. Adjust width, if necessary, until needle is

aligned directly above left hole in button.

6. Turn hand wheel toward you to take one

stitch in left hole, then continue to turn

hand wheel to carefully place needle in op­
posite hole.

• Run machine slowly taking approximately

six stitches to secure button.

• Remove work from machine leaving 4 in­

ches (10cm) of thread. Pull thread ends
through to inside of garment, and knot them
close to fabric to form a secure finish.

If sewing a series of the same buttons is

desired, after following the above procedure,

place garment and button under button foot.
Raise needle to position it over left hole of
button. Carefully place needle in left hole of

button and run machine slowly.

6

97

Advertising
This manual is related to the following products: