Curved seams, Reinforcing end of seam – SINGER 2001 TouchTronic User Manual

Page 49

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CURVED SEAMS

• Use a short stitch for elasticity and strength.

Use the stitch length control in the Digital
Fine Tuning section of the machine to obtain
a short stitch for curved seams. For addi­

tional information on stitch length, refer to

Chapter 3 Electronic Sewing, page 29.

If you use the seam guide, attach it at an
angle so that the edge that is closer to the

needle acts as a guide.

Stitching a Curved Seam

REINFORCING END OF SEAM

• Stitch to the edge of the fabric. (Do not sew

beyond edge of fabric.)

• Touch I'l’ reverse stitch symbol while

sewing and hold in place. Backstitch ap­
proximately 1/2-inch (1.3cm) to reinforce
end of seam. Release reverse stitch symbol.

• Raise needle to its highest position by turn­

ing hand wheel toward you and raise presser

foot. Remove the fabric by drawing it to the

back and left.

i I

Reverse Stitching

• Cut threads on thread cutter at rear of

presser bar.

For additional information on reverse stitch­
ing, refer to Chapter 3 Electronic Sewing,
page 32.

43

Advertising
This manual is related to the following products: