Threading the machine, Preparation – SINGER 2001 TouchTronic User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
threading the machine
PREPARATION
• Place spool of thread on horizontal spool pin
A. If spool being used has a thread retaining
slit B, it should be placed against the spool
cushion to the right.
• Select correct spool holder according to
type and diameter of spool being used. The
diameter of the end of the spool holder
should always be larger than that of the
spool itself.
• Press spool holder C f/rm/y against spool.
• Raise the needle and take-up lever to
highest position by turning the hand
wheel toward you.
•
• Raise the presser foot.
Step 1
Snap thread into thread guide post D.
Step 2
• Thread the rear thread guide E. Pass
thread under flange, then over to the far
right end of cylinder.
18