SINGER 2001 TouchTronic - Manual (Page 14)

Attaching One-piece Presser Foot
B
Attaching Darning and Embroidery Foot
Removing One-piece Presser Foot
and Presser Foot Shank
• One-piece presser feet included in your ac­
cessory box that are removed this way are:
zipper foot
button foot
tailor tack foot
• Raise needle and take-up lever to highest
position by turning the hand wheel toward
you.
• Raise presser foot.
• When changing one-piece presser feet or
removing presser foot shank, insert the
edge of a coin in the slot of the presser foot
screw, as illustrated. Turn to loosen, and
then after changing foot, turn to tighten
presser foot securely.
• Loosen presser foot screw A and remove
the foot, guiding it to the right.
Attaching One-piece Feet
• Hook one-piece foot around the presser bar
and tighten presser foot screw.
Attaching the Even Feed Foot
• Guide Even Feed foot into position from
back of machine, making sure the movable
arm straddles the needle-clamp B.
• Tighten presser foot screw securely with a
coin.
• To remove, loosen screw and guide foot to
the right and away from you.
Attaching the Darning and Embroidery
Foot
• Remove one-piece presser foot as pre­
viously instructed. •
• Guide darning and embroidery foot into
position from back of machine. Make sure
lifting finger C is above needle-clamp B.
• Tighten presser foot screw with coin.
• To remove, loosen screw and guide foot
away from you and to the right.