SINGER 2001 TouchTronic - Manual (Page 108)

Switch machine off.
Push buttonhole lever up as far as it will go.
Remove one-step buttonhole foot. Push back
A. Snap down B.
CUTTING BUTTON OPENING
• Place a pin across the cutting space at each
end of the buttonhole to protect bar tacks.
• Use a pair of small, sharp scissors to cut the
button opening.
• Insert blade in center of the buttonhole cut­
ting space and cut from this point in both
directions.
Be sure to check that the button slides
through the opening on your test sample. To
adjust buttonhole cutting space, see page 95.
Cutting Button Opening
94