Applique, Preparation, Method 1 – SINGER 2001 TouchTronic User Manual
Page 61: Method 2, Method 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
APPLIQUE
Preparation
Make a test sample to decide which of the
following methods is the most appropriate for
your fabric and design. Mark design on piece
of fabric to be appliquêd. Cut out design leav
ing about 3/4-inch (2cm) margin all around.
Position the design.
Baste it to the fabric.
Method 1
• Touch pattern and stitch width for desired
appliqué stitch. Adjust stitch length to a set
ting of 3 or iess.
• Follow the outer edge of the design with a
decorative stitch.
• Trim away the excess fabric on the outer
edges of the stitching.
Method 2
• Touch I straight stitch.
I
• Outline the entire design with a short stitch.
• Trim raw edges of the design to the straight
stitching and remove basting.
• Select suitable stitch pattern and stitch
width desired, and set stitch length on a
satin stitch setting for a closely spaced
stitch, 3 or less.
• Stitch, following the straight stitch outline.
This method will produce a smooth over
edged finish, with no raw edges to be trim
med after stitching.
Method 3
• Purchased motifs can be appliqued quickly
and easily by using either a straight or
decorative stitch.
Method 3
55