Turning square corners, 1) outside corner, 2) inside corner – SINGER 14SH654 Finishing Touch (LED) User Manual
Page 82
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fold the fabric with the wrong sides together and
sew.
Press the pin tucks in the same direction.
Turning Square Corners
(1) Outside Corner
• Cut out approximately 2 cm (51/64 inch) from the
corner, in line with the overedge seam edge.
• Sew one stitch beyond point (A) and stop.
• Raise needle and presser foot.
• Pull the fabric to the rear of the machine just
enough to release the thread caught on the finger
of the throat plate.
Note: Presser foot has been removed to show
detail.
• Turn the fabric and lower the presser foot so that
the knife is positioned in line with the cut edge.
• Pull slack threads up, then start to sew.
(2) Inside Corner
Cut fabric at seam edge.
2 cm
81