KLING & FREITAG K&F CD 44 Digital System controller - Manual (Page 26)

User's manual K&F CD 44 Digital System Controller
KLING & FREITAG GMBH © 2014 Version 11.6 Page 26 of 77
7.5 Setups in editing mode
All settings are executed in real time.
There are three different editing modes:
1. Editing mode with one editing line
2. Editing mode with several editing lines
3. Selection Mode with selection lines
7.5.1 Editing mode with one editing line
In order to follow the aforementioned example, we will show the editing mode with one
editing line: the editing mode Contrast of the submenu item Display.
Changing Parameters
The underline marks if you can change the parameters in increments of 1 or 10. (In other
editing modes, further increments are also possible). In the illustration below, the underline is
below the zero, this means, the ones digit will be changed.
You can change the parameters in increments of one by turning the knob f.
If you wish to change the parameters in increments of 10, then push the knob once so that
the cursor blinks. In this case it is blinking in the ones place. Turn the knob to the left so that
the underline is under the tens place (the cursor is no longer blinking). Then you can change
the parameters in increments of 10 by turning the knob.
Confirm changes
To confirm the changes made in the current editing mode, push the EXIT button 2x. The
screen returns to the preceding submenu. The settings are kept until a new setup is loaded
or until the settings are changed. Changes that have been made in fewer than 10 seconds
before the device is shut down are lost after it is turned off. Please wait at least 10 seconds
after having made final changes before turning off the controller. EXIT
To permanently store changes in a setup, save the setup at: <Setup » Save As>.
The following changes are not saved with a setup and are, therefore, maintained even after a
setup has been loaded: InSelect, EQ 31-Band, Display, IP-Address, Units.
Undo (cancel changes)
To undo the changes made in the editing mode, turn the knob while the cursor is blink-
ing (push the EXIT button 1x) to the left until the position indicator (arrow) points to the
undo symbol. Then push the knob. The entries are cancelled and the screen returns to the
preceding submenu. EXIT
Example of a display in the editing mode with one editing line: