KLING & FREITAG K&F CD 44 Digital System controller - Manual (Page 38)

User's manual K&F CD 44 Digital System Controller
KLING & FREITAG GMBH © 2014 Version 11.6 Page 38 of 77
as cardioid rear,
emitting to the back
NomLS2 HC-F /
NomLT HC-F /
NomXLS HC-F /
NomXLT HC-F Nomos LS2 / Nomos
LT / Nomos XLS /
Nomos XLT in
normal mode as
hypercardioid front,
emitting to the front all K&F loudspeaker
NomLS2 HC-R /
NomLT HC-R /
NomXLS HC-R /
NomXLT HC-R Nomos LS2 / Nomos
LT / Nomos XLS /
Nomos XLT in
normal mode as
hypercardioid rear,
emitting to the back all K&F loudspeaker
NomLS2 HC-F60Hz /
NomLT HC-F60Hz /
NomXLS HC-F60Hz/
NomXLT HC-F60Hz Nomos LS2 / Nomos
LT / Nomos XLS /
Nomos XLT in
sub-bass mode as
hypercardioid front,
emitting to the front all K&F loudspeaker
NomLS2 HC-R60Hz /
NomLT HC-R60Hz /
NomXLS HC-R60Hz /
NomXLT HC-R60Hz Nomos LS2 / Nomos
LT / Nomos XLS /
Nomos XLT in
sub-bass mode as
hypercardioid rear,
emitting to the back all K&F loudspeaker
Sequenza 5:
Name LS-Block Application Combination with
LS-Block
S5W FR Sequenza 5 in full-
range mode -
S5W LCut Sequenza 5 in low-
cut mode all K&F Subwoofer
S5B Sequenza 5B in
normal mode all K&F loudspeaker
2. Select <LS-Block » Flat>
The LS-Block 'Flat' is a distinctive feature. It is intended for special uses such as processing
or transmitting line signals, or using third party products or Kling & Freitag speakers
where no LS-Block is available. In this LS-Block, all filters are switched off, and there is
also no subsonic filter intended! It is still possible, though, to equalise signals with the
help of the PEQs and the EQ 31 band.
When using speakers with the LS-Block 'Flat', the limiter must be set at <Out » Output1>
through <Output 4 » LimReduction> based on the power ratings (W) of the speakers.
You can find the power ratings of the speakers in the information provided by the
speaker manufacturer (no liability for misrepresentation). With the following diagram,
you can match the power specifications from the speaker manufacturer with the value
for LimReduction that we recommend. We, therefore, recommend initially setting the
LimReduction lower than recommended, and then carefully approaching the correct
setting for the speaker.