KLING & FREITAG K&F CD 44 Digital System controller - Manual (Page 42)

User's manual K&F CD 44 Digital System Controller
KLING & FREITAG GMBH © 2014 Version 11.6 Page 42 of 77
This ‘Rack Unit’ is designed for two power amplifiers of the same power ratings.
If you want to use power amplifiers with different specifications in a rack, be sure to wire the
rack according to your requirements. Pay special attention to the assignment of the speaker
output connectors.
8.2 K&F 'System Rack' Connecting Diagram
Especially for use with the Sequenza 10 systems on tour, Kling & Freitag recommends setting
up K&F system racks with one of each of the following:
K&F controller CD 44 / K&F connector panel CP 4 / power amplifier LAB GRUPPEN FP 10000Q
This system rack is also recommendable for a variety of other uses with Kling & Freitag
systems.
You will find an example of use at Setup Example 13.
When using the Sequenza 10 N / W Systems without the Connector Panel CP 4, the channels
for the LS-Blocks Seq10LF/HF (FR or LCut) and LS-Blocks Seq10LF (FR or LCut) in the CD 44
must be exchanged with one another! Apparent when you compare setup Example 13 with
setup Example14.