Avery Dennison 6035 Equipment Manual - Manual (Page 43)

S c a n n i n g a B a r C o d e
The application you are running controls when you can scan a bar
code. When it indicates to scan:
1. Attach the safety strap to your wrist.
2. Point the scanner at a slight angle approximately four to eight
inches from the bar code symbol.
3. Press the trigger or other key specified by your System
Administrator.
The Laser Scan LED lights after a successful scan. This light is
at the bottom of the keypad on the 4-line/33 Key Printer and on
the right side of the display on the 8-line/48 Key Printer.
If the bar code does not scan:
◆ Change the angle of the scanner and press the trigger again.
◆ Make sure the scanner window is clean. See "Cleaning the
Scanner Window" later in this chapter.
◆ Try scanning another bar code that you have scanned
successfully. If that scan is successful, this means the first bar
code cannot be decoded. See Chapter 8, "Troubleshooting."
5-2 Using the Laser Scanner TC6035EZEM Rev. C 10/98