Avery Dennison 6035 Equipment Manual - Manual (Page 66)

To run the Print Speed test:
1. Load supplies in non-peel mode.
2. From the Printing sub-menu, scroll with the arrow keys until
you highlight Print Speed. Press e . You will see:
Ready to print
3. Press e to print the test sample. Press b to exit.
4. Use the metric scale shown or a metric ruler to
measure your test sample. If your test sample
measures more than 101 mm or less than 99
mm, save your test sample and call Service.
To run the Gray Scale test:
1. Load supplies in non-peel mode.
2. From the Printing sub-menu, scroll with the
arrow keys until you highlight Gray Scale.
Press e
. You will see:
Ready to print
Using Diagnostics 7-11 TC6035EZEM Rev. C 10/98