Avery Dennison 6035 Equipment Manual - Manual (Page 49)

C l e a n i n g t h e P r i n t h e a d
Clean the printhead
◆ after using 7-10 rolls of supplies.
◆ in extreme temperatures, humid conditions or dirty
environment.
◆ when you see voids in the print.
◆ after a supply jam.
Use isopropyl alcohol on the interior areas only, never on the
exterior. Do Not use silicone to clean or lubricate.
Use any of the following items to clean the printhead:
◆ soft cloth moistened with isopropyl alcohol
◆ Monarch Cleaning Pen #114226
◆ Monarch 6076 T M Cleaning Kit
Do Not use sharp objects to remove adhesive or label particles
from the printhead area. Do Not touch the printhead with your
fingers. These actions may damage the printhead and void your
warranty.
Always ground yourself by touching something metal before
cleaning the printhead. This prevents electrostatic discharge,
which may damage your printer.
To clean the printhead:
1. Turn the printer off.
2. Open the supply cover and remove the supply roll.
3. Check the supply holder for adhesive buildup, and clean if
necessary.
4. Ground yourself by touching something metal other than the
printer.
6-4 Care and Maintenance TC6035EZEM Rev. C 10/98