Avery Dennison 6035 Equipment Manual - Manual (Page 79)

When you first turn on the
printer, the line moving
across the bottom of the
screen stops and the logo
screen never disappears. Turn off the printer. Then, turn it back on
while holding down the f key. When
messages appear, release the key. Note
the message on the screen when the
messages stop scrolling and report the
problem to the System Administrator.
Problem Solution
Printer fails to respond to
the keypad during data
entry. (A low battery or
recharge message does
not appear on the display.) Switch to a fully charged handle.
Scanner will not scan a
bar code. See "Scanning Tips" in Chapter 5.
The bar code symbol may have voids.
Scan a previously scanned bar code to
verify that the scanner is working. If the
scanner is not working, ask your System
Administrator to run a scanner test.
If these solutions do not work, call Service.
8-2 Troubleshooting TC6035EZEM Rev. C 10/98