Avery Dennison 6035 Equipment Manual - Manual (Page 72)

2. Press e . You will see:
Dot# XX GOOD
Value = ###
Valid values are 244-308 (inclusive). If the value is not within
range, please make a note and call Service.
The test continues (with results displayed on
the screen) until each dot resistance has
been tested and the results displayed.
3. The test concludes by displaying:
Avg dot = XXX
Enter for dot value
Esc to leave.
Press b.
To run the Temperature test:
1. From the Printhead sub-menu, scroll with the arrow keys until
you highlight Temperature. Press e . You will see:
Printhead Temp = ###
OK
The value may fluctuate
on the screen.
The temperature of the printer depends upon the number of
labels printed and the operating environment.
Using Diagnostics 7-17 TC6035EZEM Rev. C 10/98