Avery Dennison 6035 Equipment Manual - Manual (Page 74)

C h e c k i n g t h e M o t o r
The motor test verifies the functionality and speed of the motor by
discharging labels.
To test the motor:
1. From the Hardware Test sub-menu, press e . The motor
will run and dispense labels.
2. Press b to exit.
S e r v i c e D i a g n o s t i c s
This menu selection is password-protected for Service use.
C a l i b r a t i n g L a b e l s
To run the Calibration Test:
1. From the Printer menu, scroll with the arrow keys until you
highlight Calibration. Press e . You will see:
Reloading
Trigger to feed
ESC to Calibrate
2. Load the supply and feed it through the label path. Press the
trigger to feed the supply.
3. Press b to perform the calibration test. You will see:
Stock Type:
2) Paper_
Using Diagnostics 7-19 TC6035EZEM Rev. C 10/98