Beisler 1265-4 - Manual (Page 14)

Operating Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
B-4
B.2
Functions of the machine
B.2.1 Operating principle and machine cycle
Operating principle:
The automatic single-head serging machine 1265-4 allows the automated
serging of inseams and side seams of trousers panels, with or without knee
lining. The sewing unit automatically sews and serges cleans the fabric con-
tour and incorporates the fullness for the knee lining, if required.
The trousers panels are sewn in separate machine cycles:
• the inseam or side seam of the rear trousers panel,
• the inseam or side seam of the front trousers panel with knee lining on
top,
• the inseam or side seam of the front trousers panel with knee lining on
bottom.
NOTE - Applications
The machine has been designed predominantly for serging
trousers panels. However, it can also be used for processing
other sewing pieces, e.g. sleeves, short trousers, etc.
Machine cycle, Fig. 2:
The short seams can be serged manually at the sewing head 2 prior to
the sewing of the inseam or side seam.
• The trousers panels are stocked on the upper tray
5, the knee linings are stocked on the lower tray
4. The trousers panel is placed onto the working
plate, the corresponding knee lining is aligned to
the trousers panel with the hems being flush.
• At the optional bonding station 6, the front and
rear trousers panels can be secured to each other
using a bonding mesh.
• Both trousers panels are routed below the con-
tour guide 3 and lined up at the stop of the se-
wing head 2. A photocell starts the sewing pro-
cess. The fully automatic machine cycle is star-
ted.
• During the sewing process, the contour guide 3 and the puller of the
transport unit 7 control the routing of the seam.
• If required, the top and bottom transport units of the sewing unit incor-
porate fullness.
• The transport unit 7 transports the sewing piece from the working plate
to the stacker 8 where the sewing pieces are stacked on top of each
other.
• As soon as the sewing process starts at the sewing head 2, the next
trousers panels can be secured at the bonding station.
Fig. 2