Beisler 1265-4 - Manual (Page 48)

Service Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
C-12
C.5
Maintenance
NOTE - Repairs
Any repairs to the machine must only be carried out by an
authorized Technical Service or by personnel that has
been instructed about the setting up and maintenance of
the machine on the occasion of a training by the supplier
or manufacturer of the machine.
NOTE - Liability
Use only original spare parts for installing or replacing
machine components.
The manufacturer and supplier will not assume liability for
spare parts from third-party suppliers.
C.5.4 Removing/installing the operating panel
1. Disconnect machine from power supply.
2. Remove two locating screws and disconnect interface connector.
3. Remove retaining screws from operating panel bracket.
4. Remove operating panel, install new panel and secure using screws.
5. Connect the interface cable connector to the receptacle and secure
it using the two locating screws.