Beisler 1265-4 - Manual (Page 60)

Service Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
C-24
C.5
Maintenance
C.5.17 Inputs and outputs of the main PCB
Fig. 15: The inputs and outputs for controlling the machine functions
are connected to the terminal strips X24-X27.
1 X 24 Inputs
2 X 25 Outputs
3 X 26 Outputs
4 X 27 Inputs
X24 Inputs
ES01
GND link (FZ 15) ES02
Bonding clamp ES04
Bonding start ES05
ES08
Thread monitor ES09
Photocell C-machine ES10
ES11
ES12
Prog. start photoc. ES13
ES14
Tray photoc. ES15
Cont. guide photoc. ES16
X25 Outputs
Pressure foot up Y20
Tension blowing Y24
Contour roller Y38
Fly blowing Y31
Stacker start Y32
Stacker motion Y35
X26 Outputs
Chain cutting Y22
Table blowing Y23
Dirt aspiration Y25
Contour guide down Y26
Puller down Y27
Roller down Y28
High foot pressure Y40
Pocket pouch stop Y29
Transport up Y36
Arm swinging Y37
Bonding clamp down Y03
Bonding station down Y04
Pressure foot up C
Y01
Chain / Dirt aspiration C Y05
Puller swinging
Y39
X27 Inputs
Photocell Y22
Fig. 15
NOTE - Function ES02
If photocell 15 is installed, remove link in ES02
and set basic parameter 09 (photocell 15 on /
off) to value 01.